Check Fuel; The Engine Switch & Eco Switch - Energizer EZG Series User Manual

(1). Open the Oil Maintenance Cover.
(2). Remove the Oil Cap and wipe the Dipstick clean.
(3). Check the oil level by inserting the Dipstick into the filler neck without
screwing it in.
(4). If the wet line on the Dipstick is between "L" position and "H" position, the
oil level is OK. If the oil cannot reach "L" position, the oil level is too low. Fill
to the upper limit of the oil filler neck with the recommended oil.
(5). Tighten the Oil Cap and reinstall the Oil Maintenance Cover.
(6). Check generator for oil leakage.
Make certain the generator is on a flat, level surface when check the
engine oil.
The engine is equipped with a low oil sensor that will stop the engine
automatically when the oil level falls below a critical threshold.
When the engine shuts down automatically by the low oil protection, the
LOW OIL LEVEL LED (yellow) will come on, and unless you re-fill with oil,
the engine will not start again.

5.2 CHECK FUEL

<<21>>
Do not smoke or allow flames or sparks where the generator
is refueled or where gasoline is stored.
Refuel in a well-ventilated area with the engine stopped.
DO NOT ill above the Red Level.
Check the fuel BEFORE EACH USE with the generator on a level surface and
the engine stopped.
(1). Checked the fuel level in the fuel tank through the Fuel Gauge. If the red
mark in the Fuel Gauge 1 is close to "E" position, means the fuel level in
the fuel tank is lower. If the red mark in the Fuel Gauge is close to "F"
position, means the fuel level in the fuel tank is higher.
(2). Refuel if necessary.
(3). After ill the fuel, make sure the Fuel Cap is tightened
securely. (4). Check generator for fuel leakage.
Use only unleaded gasoline.
Never use an oil/gasoline mixture.
Fuel tank capacity: 7.4L.
Make certain the generator is on a flat, level surface when check the fuel.
5.3 THE ENGINE SWITCH & ECO SWITCH
ECO SWITCH
ENGINE SWITCH
<<22>>