Ac Operation; Use The Generator - Energizer EZG Series User Manual

6. AC OPERATION

PLUG

6.1 USE THE GENERATOR:

After starting the engine, let it run for 2 or 3 minutes to warm up, then you
can use the generator as follows:
(1). Turn the ECO Switch to "ON" position to use Economy Control System.
This system controls the engine speed according to the connected load.
The results are better fuel consumption and less noise.
(2). Connect plug to the generator AC Receptacles for AC electric devices.
(3). Turn on the electric devices for operation.
Be sure any electric devices are turned off before plugging them in.
The ECO Switch must be turned to "OFF" position when using
electric devices that require a large starting current, such as a heavy
compressor or some high electrical loads.
<<25>>
The ECO Switch must be turned to "OFF" position when using
electric devices that require a large starting current, such as a
heavy compressor or some high electrical loads.
Be sure all electric devices including the lines and plug
connections are in good condition before connection to the
generator.
Be sure the total load is within generator rated output.
Be sure the receptacle load current is within receptacle rated
current.
Be sure to ground (Earth) the generator when the electric device
is earthed.
If the generator is overloaded (in excess of rated power), or if
there is a short circuit in a connected appliance, the OVERLOAD
LED (red) 5 will go ON, and the current to the connected
appliance(s) will shut off, and the READY LED (green) 4 will go
OFF.
The Reset Button can be used to recover output of the
generator under the condition of overload protection, and
unnecessary to restart engine overall. But at first check
and correct the problem, if there is a short circuit in a
connected appliance or wire.
When an electric motor is started, the OVERLOAD LED (red) 5
may come on. This is normal if the OVERLOAD LED (red) 5 goes
off after a few seconds.
<<26>>