Replacing A Card - Huawei S2700 Hardware Installation And Maintenance Manual

S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
Step 5 Take out the new optical module from the package. Ensure that the optical module is correctly
oriented and gently push it into the optical port until you hear a click.
Step 6 Identify the optical fibers to be connected to the optical module. Remove the dust caps from
the optical fibers and insert the optical fibers to the bores of the optical module.
----End
Follow-up Procedure
If the new optical module does not work, unplug the optical fibers and clean their connectors
in one direction with an alcohol swab. Then, re-connect them. If this fails to resolve the issue,
contact the equipment supplier or local maintenance personnel for technical support.

11.3 Replacing a Card

Context
Some switch models support pluggable interface cards. This section describes how to replace
a 4-port front card. The replacement method is the same for other cards. For details about
which models support what cards, see "Cards" in the Hardware Description.
Only switch models S3700-HI, S5700-HI, S5710-EI, S5710-HI, S5720-C-EI, S5720-PC-EI,
S5730-SI, S5730S-EI, S5720-HI, S6720-EI, and S6720-SI support hot swappable cards. To
replace cards of other switch models, power off the switch before removing the card from the
switch.
Tools and Accessories
l
l
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. When wearing an ESD wrist strap, ensure that it is in
close contact with your wrist and grounded properly.
Step 2 If the card you want to replace is not hot swappable, power off the switch.
Issue 13 (2017-11-20)
NOTE
The new optical module must have the same optical parameters as the remote optical module connected
to it.
NOTICE
ESD wrist strap or ESD gloves
Phillips screwdriver
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Maintaining a Switch
83