Huawei S2700 Hardware Installation And Maintenance Manual page 124

S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
Step 11 To complete the assembly of the other end, repeat steps 1 to 10.
----End
Assembling an Unshielded RJ45 Connector and Ethernet Cable
Context
Figure 13-28
Figure 13-28 Components of an unshielded RJ45 connector and cable
A. Plug of connector
Procedure
Step 1 Remove a 16-mm (0.63 in.) long section of the jacket, as shown in
When you remove the shield layer, do not damage the insulation of the twisted-pair cable.
Figure 13-29 Removing the jacket of a twisted-pair cable (unit: mm (in.))
Step 2 Align the four pairs of wires and cut the ends neatly, as shown in
connections between the wires and the pins are listed in
Issue 13 (2017-11-20)
shows the components of an unshielded RJ45 connector and cable.
A
B
C
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B. Jacket C. Twisted-pair wires
Table
13 Appendix
Figure 13-29.
Figure 13-30. The
13-23.
116