Huawei S2700 Hardware Installation And Maintenance Manual page 42

S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
Figure 5-10 Installing rear mounting bracket guide rails (418-528 mm [16.5-20.8 in.] between
front and rear mounting rails)
Step 6 Install the switch in the cabinet.
l
l
Issue 13 (2017-11-20)
If you have installed front and rear mounting brackets on the switch, perform the
following steps:
a. Place M6 screws on the two lower floating nuts on the front mounting rails. Reserve
a clearance between the top of the screws and the floating nuts for installing front
mounting brackets.
b. Align the rear mounting brackets with the rear mounting bracket guide rails. Then,
gently slide the switch into the cabinet along the guide rails.
c. Align the holes on the front mounting brackets with floating nuts on the front
mounting rails, place the recesses at the bottom of the front mounting brackets on
the M6 screws, and then use a Phillips screwdriver to tighten the M6 screws.
In Figure 5-11, the distance between front and rear mounting rails is 545-655 mm
(21.5-25.8 in.).
Figure 5-11 Supporting the switch using front and rear mounting brackets
If you have installed cable management frames and rear mounting brackets on the
switch, perform the following steps:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
a
c
5 Installing a Switch
b
34