Huawei S2700 Hardware Installation And Maintenance Manual page 89

S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
l Unplug the optical fibers from the optical module before removing it. Install or remove
l If an optical module cannot be completely inserted into an optical port, turn the optical
l Cover unconnected optical modules with dust plugs.
Tools and Accessories
l
l
l
l
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. Ensure that the ESD wrist strap is grounded and in a
close contact with your wrist.
Step 2 Record the location of each optical fiber on the old optical module and check whether the
labels on the optical fibers are correct and clear. If any labels are unclear, replace them and
ensure that the details are correct.
Step 3 Release the locking clip on the fiber connector, gently push the fiber connector inward, and
then pull out the optical fiber. After removing the optical fibers from the optical module,
cover the connectors with dust caps.
The locking clip varies on different fiber connectors.
l
l
l
Figure 11-3 LC/PC connector
Issue 13 (2017-11-20)
NOTICE
optical fibers carefully to avoid damaging the fiber connectors. Applying too much force
to the optical fibers may damage the optical module.
module over and try again.
ESD wrist strap or ESD gloves
Dust caps
Dust plugs
Alcohol swab
Figure 11-3 shows the locking clips on an LC/PC connector. Hold down the locking
clips when pulling the optical fibers.
Figure 11-4 shows the locking clip on an MPO connector. The locking clip is released
automatically when you pull the MPO connector.
Figure 11-5 shows the locking clip on an SC/PC connector. The locking clip is released
automatically when you pull the SC/PC connector.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Maintaining a Switch
81