S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
Figure 13-18 Fitting the metal shell onto the twisted-pair cable
Step 4 Fit the metal shell onto the twisted-pair cable until the shield layer is covered completely.
Along the edge of the metal shell, cut off the aluminum foil shield layer and ensure that there
is no surplus copper wire. The exposed twisted-pair cable is about 20 mm (0.79 in.) long, as
shown in
Figure 13-19 Removing the shield layer of a twisted-pair cable (unit: mm (in.))
Step 5 Lead the four pairs of twisted-pair wires through the wire holder, as shown in
and
Figure 13-20 Leading wires through the wire holder
Issue 13 (2017-11-20)
Figure
13-19.
Figure
13-21. Ensure that the colored wires are in the correct location in the cable.
C
G
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Appendix
Figure 13-20
112