Adjustments; Pressure, Pto Drive - Stiga Titan Series Workshop Manual

4.9 Adjustments

4.9.1 Pressure, PTO drive

The PTO drive has two adjustable pres-
sures:
• Max pressure, factory set to 220 bar.
• Brake pressure, factory set to 10 bar.
A. Adjusting brake pressure.
B. Adjusting max pressure.
C. MT1, measurement output for brake
pressure.
D. MP, measurement output for max
pressure.
Adjusting max pressure
1. Connect a pressure gauge to meas-
urement output MP.
2. Start the engine and activate the PTO
without having any accessories con-
nected.
3. Adjust the pressure using valve B and
read off the pressure on the pressure
gauge.
Adjusting brake pressure
1. Connect a pressure gauge to meas-
urement output MT1.
2. Attach a cutting deck, start the engine
and activate the PTO.
3. Switch off the drive and read off the
brake pressure on the pressure
gauge.
4. Adjust valve A and repeat the proce-
dure until the brake pressure and stop
time have reached the desired level.
Note The brake pressure must not
exceed 35 bar.
The stop time must not exceed 7
seconds.
The pressure must not exceed 220
bar, higher pressure creates a dan-
ger of damaging other components.
WORKSHOP MANUAL
TITAN
Chapter
4 - Hydraulic system
A
B
C
D
EDITION Page
2018 83