Adjusting Drive Belts - Stiga Titan Series Workshop Manual

4. Remove the M10 screws G (3x) that
hold the carrier plate/pulley to the fly-
wheel as follows:
•Block the flywheel with a
screwdriver or similar and slacken off
the screws.
•Unscrew all the screws half way in a
first stage.
•Then rotate the flywheel one revolu-
tion and remove all
screws.
5. Use a spanner or similar to push lever
arm C down to release the pressure of
the tensioner wheel against the belt.
6. Pull out the pump with the carrier
plate/pulley. Twist off the belt and re-
move it by threading it out between
the carrier plate and the flywheel.
Assemble all parts in the reverse order.
Adjust the belt as necessary, see "4.7.6".

4.7.5 Adjusting drive belts

(V-belt / Poly-V)
1. Screw an M8-80 screw into A. Slack-
en off the two screws C.
2. Tighten screw A until the distance be-
tween the screw head on "spring" and
the plate (distance B) is 12 mm.
3. Tighten the screws C.
4. Remove the M8-80 screw.
The distance must be checked after sev-
eral hours operation to check that the dis-
tance is the same.
Attention!
The belts are supplied in kits of two
belts that are classed together.
Never change just one belt. Never
mix belts from different kits.
WORKSHOP MANUAL
TITAN
Chapter
4 - Hydraulic system
B
C
EDITION Page
2018 78
C
A
B