2.2.2 Removing the front side
covers and the control panel
Components are accessed as follows:
1. Remove the cover by twisting the
screw with clamp A, see image to the
right.
2. To remove the whole side cover re-
move the screws B (5x) for machines
with cab; machines without a cab have
screws B (5x), C (2x) securing the cov-
er. When reinstalling use silicone
spray along the sealing trim.
3. If necessary, remove the other cover
by first removing the three control
knobs for the hand lever valves, twist
while pulling upwards. Then unscrew
screws D (4x), E (2x), F.
WORKSHOP MANUAL
TITAN
Chapter
2 - Chassis and bodywork
B
F
EDITION
2018
A
E
Page
22
B