Adjustments; Adjustment Of The Cutting Height; Adjustment Recommendations - Stiga Autoclip 720S User Manual

The user must make any adjustments according to the procedures described in
this manual. Do not make any adjustments which are not expressly indicated in
this manual. Any special adjustments not expressly indicated in this manual must
only be carried out by personnel from the Manufacturer's authorised service
centre.
EN
Before setting the cutting height of the blade, make sure the robot has been turned off safely
(see "Robot Safety Stop").
Use protective gloves to prevent cutting your
hands.
1. Disable the antitheft alarm to prevent it from
going off (see "Programming Mode").
2. Unscrew the knobs (A) and lift the hood.
3. Unscrew the screw (C).
4. Lift or lower the cutting unit (D) to set the
desired cutting height. The value is shown on
the graduated scale (E).
5. Once completed, fasten the screw (C).
Reduce the cutting height gradually. It is
recommended to reduce the height at least by
1 cm (0.40 in.) every 1-2 days until the ideal
height is reached.
User's manual

ADJUSTMENTS

ADJUSTMENT RECOMMENDATIONS

ADJUSTMENT OF CUTTING HEIGHT
28
knobs (A)
screw (C)
cutting unit (D)