Stiga Titan Series Workshop Manual page 33

Contents
3.1 Description .........................................32
3.1.1 Removing the power steering servo 32
3.1.2 Installing the power steering servo ..35
3.1.3 Replacing O rings in the power
steering servo .........................................35
3.1.4 Replacing O rings in the hydraulic
cylinder ...................................................39
General description
The machines are equipped with a steering system with a hydraulic servo. A hydraulic
cylinder is connected between the front and rear frame. The hydraulic cylinder positions
the frames at different angles in relation to each other.
This chapter contains a short description of how the steering works, how repairs are car-
ried out and how wear components of the steering system are adjusted.
WORKSHOP MANUAL
TITAN
3 Steering system
Chapter
3 - Steering system
EDITION Page
2018 31