Servicing - Stiga Titan Series Workshop Manual

1.6 Service
Each new machine is supplied with a serv-
ice book. The service log should be
stamped at every service carried out by an
authorised workshop. The service book is
part of an active aftermarket program and
must be stored in a safe place during the
Service point
Water separator, check
Filter in water separator, cleaning
Fuel filter, replace
Tyre pressure, check, adjust
Engine oil, filter, change
Hydraulic oil, change/clean
Wheel motors , change oil
Belt transmissions, check
Cooling system, change coolant
Battery, check
Air filter, clean pre-filter
Air filter, change inner filter
Lubrication
Tightening / control of hydraulic cou-
plings and hydraulic tubes
Adjusting valves
Grinding valves
Tank venting valve, change/ clean
Check the correct tightening of the fix
screw of the lift arms support
Check the tightening torque of the
screws (A) and (B) of the joint.
1
ATTENTION
Correct torque
385 Nm
WORKSHOP MANUAL
TITAN
Chapter
1 - General instructions
lifetime of the machine. The service book
must accompany the machine if it is sold as
used.
The service points are given in the table
below. Descriptions of how the proce-
dures are to be carried out are given after
the table.
Hours of operation/Calendar
months
1st time
50/12
50/12
50
50
50/12
50/12
2
EDITION
2018
See the
instructions
Interval
50/-
400/-
200/12
400/12
200/12
200/-
in the
1000/24 instructions for
use paragraph
50/-
maintenance
200/-
200/-
50/-
50/-
1000/-
2000/-
1000/24
See the
400/12
drawing (1)
See the
400/12
drawing (2)
Page
9