Adjusting Door; Windscreen Wiper Motor - Stiga Titan Series Workshop Manual

2.4.2 Adjusting door

1. Slacken off the existing nuts enough
that the locking pin can be moved.
2. Move the locking pin (height, side-
ways) to the desired position and then
tighten the nuts again.
If incorrectly set there is a risk that the
door cannot be closed, or that there is
play between the door and the cab that
allows water to leak in.

2.4.3 Windscreen wiper motor

1. Remove the screw on the plastic cov-
er that covers the windscreen wiper
motor.
2. Unscrew the two wiper arms that are
each secured by a nut.
3. Undo the lower screws
A (2x).
4. Slacken off the nuts (B) (2x) inside the
wiper arms.
5. Lift off the washer fluid tank.
6. Remove the lock rings C (2x) and re-
move the washers and rubber gas-
kets.
7. Remove the plastic cover that covers
the windscreen wiper motor.
8. Then lift off the motor.
Reassemble in reverse order.
WORKSHOP MANUAL
TITAN
Chapter
2 - Chassis and bodywork
B C
EDITION
2018
A
Page
27