Assembly; Check - Stiga Titan Series Workshop Manual

5.3.3 Assembly

1. Lubricate the cable through the end
seals. Run the cable back and forth
until oil has covered the length of the
cable.
2. Install the cable in the same way as
the one installed previously. Also see
the image below.
3. Adjust the cable. See "5.3.5".

5.3.4 Check

• Check that the cable can move easily in
the housing along the whole length of
the stroke.
• Check that the cable is free of sharp
kinks and other damage. The casing
must be fault free so that water cannot
penetrate.
• Check that the end seals are intact.
WORKSHOP MANUAL
TITAN
Chapter
5 - Control cables
EDITION Page
2018 91