Description; Removing The Power Steering Servo - Stiga Titan Series Workshop Manual

3.1 Description

The oil flows in the hydraulic steering are
described in chapter 4.
3.1.1 Removing the power steer-
ing servo
Machines with cab
1. Remove the cab. See "2.4.5".
2. Remove the duct in front of the steer-
ing bracket through which the heating/
AC is routed by:
A. Unscrew the screws A (12x) that
secure the cover for the heating/AC
duct.
B. Remove the plastic cover that goes
up at the steering bracket by removing
the four screws. Then remove the
plastic protection on each side of the
plastic cover and remove the screws
inside. Then twist the whole cover off.
C. Lift the rubber mat off the floor.
D. Then unscrew the screws B (4x)
on each side of the duct and the
screws C (4x) screwed in under the
seat. Then lift off the section of duct
routed along the floor.
3. Remove the upper section of the
steering bracket by unscrewing the
four screws and the knob of the park-
ing brake.
4. Remove the steering bracket protec-
tion by unscrewing the two remaining
screws.
5. Remove the inner front cover by un-
screwing the two remaining screws.
WORKSHOP MANUAL
TITAN
Chapter
3 - Steering system
2x
EDITION Page
2018 32
B
A
2x
2x
4x