Replacing Switches; Replacing Switch Controls - Stiga Titan Series Workshop Manual

6.5.3 Replacing switches

The switches are pressed into place in
their respective rectangular holes in the
control panel. To change a switch, follow
the procedure below:
1. Remove the relevant protection to
make the switch accessible.
2. Press in the fixing hook in the connec-
tion and pull the connection from the
switch.
See figure.
Certain connections have 2 fixing
hooks.
3. Press the fixing tabs, on both sides of
the switch, against the switch. Use a
screwdriver or similar to slide the
switch up.
See figure.

6.5.4 Replacing switch controls

To remove the switch use a special
The tool reference number is in the re-
placement parts list.
Remove the button by pressing in the tool
from behind. Press until the button hops
up.
The button is easily installed by pushing
down into the switch hole.
WORKSHOP MANUAL
TITAN
tool.
Chapter
6 - Electrical system
EDITION Page
2018 114