Connections; Replacing Headlamp Bulbs - Stiga Titan Series Workshop Manual

6.5.5 Connections

All connections must be kept clean of dirt,
rust and moisture.
Use a small screwdriver to remove a flat
pin connector from the plastic holder.
Press in the screwdriver behind the con-
nection, hold the cable and pull out the
cable with the connection. To reuse reset
the catch to its previous position.
Crimping pliers can be used to restore a
flat pin connector, when it has been ex-
posed to long term wear and tear. Other
types of connectors may require special
tools for removal.
Warning!
No metal from the cable may be
visible outside the screw con-
nection. Too long stripped ca-
bles can cause short-circuits or
fires.

6.5.6 Replacing headlamp bulbs

In standard form, machines without cabs
are equipped with two 12V lamps, 20W.
They are aimed 15° from each other. Re-
place the lamps as follows:
1. Remove the cover by removing the 4
screws.
2. Remove the relevant lamp by un-
screwing the two screws and discon-
necting the electrical connection.
3. Reassemble in the reverse order.
WORKSHOP MANUAL
TITAN
Chapter
6 - Electrical system
4x
EDITION Page
2018 115