Stiga TORNADO 51 S Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Stiga Manuals
  4. Lawn Mower
  5. TORNADO 51 S
  6. Instructions for use manual
Stiga TORNADO 51 S Instructions For Use Manual

Stiga TORNADO 51 S Instructions For Use Manual

Hide thumbs Also See for TORNADO 51 S:

Advertisement

Table of Contents

See also: User Manual
S T I G A
T O R N A D O
5 1 S
5 1 S E
P R O 5 1 S
8211-0225-09

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TORNADO 51 S and is the answer not in the manual?

Questions and answers

Related Manuals for Stiga TORNADO 51 S

Summary of Contents for Stiga TORNADO 51 S

  • Page 1 S T I G A T O R N A D O 5 1 S 5 1 S E P R O 5 1 S 8211-0225-09...
  • Page 2 SVENSKA FULL 0,15 l. 3. LS 45 4. XTE 60 5. LS 45 6. XTE 60...
  • Page 3 SVENSKA 12. LS 45 0,75 mm 13. XTE 60 40 Nm 16a.
  • Page 4 SVENSKA 40 Nm 16b.
  • Page 5 SVENSKA...

  • Page 6: Using The Mower

    ENGLISH SYMBOLS USING THE MOWER The following symbols are displayed on the ma- BEFORE STARTING chine in order to remind you about the safety pre- FILL THE CRANKCASE WITH OIL cautions and attention necessary when using the machine. The symbols mean: The lawn mower is delivered without any oil in the motor crankcase.

  • Page 7: Cutting Height

    ENGLISH CUTTING HEIGHT 3. When starting a cold engine: Press down the primer fully 6 times (fig. 5,6). Shut off the motor before adjusting the When starting a warm engine the primer does cutting height. not need to be used. If the engine stops due toa Do not set the cutting height so low that lack of petrol, refill and press down the primer the blade can hit uneven ground.

  • Page 8: Cooling System

    ENGLISH The inside of the drive wheels should be cleaned Change the oil the first time after 5 hours of oper- once a season. To clean a wheel, remove the hub ation, and subsequently after every 50 hours of op- cap, screw, washer, and wheels.

  • Page 9: Changing Blades

    Always use genuine spare parts. www.stiga.com To replace the blade, slacken the screw (fig. 16). Fit the new blade so that the stamped STIGA log- otype is turned facing the blade attachment (and not facing the grass). Refit as illustrated. Tighten the screw fully to a torque of 40 Nm.
  • Page 10 ENGLISH...
  • Page 11 M O W I N G A H E A D G G P S w e d en A B · B ox 1 00 6 · S E- 5 73 28 T R A N Å S w w w. s t i g a . c o m...

This manual is also suitable for:

Tornado 51 seTornado pro 51 s

Table of Contents