Channel - Strong SRT 8203 User Manual

7.1.3 Other parameters for channel installation
Define other parameters for channel installation.
Channel Filter: Define which channels will be stored into the channel list. With the selection of FTA
Only, only open non-scrambled channels will be added into the channel list. If All
Channels is selected, all kind of found channels (scrambled and non-scrambled) will be
stored into the channel list
Country Select the country of your residence
LCN: To select if the channel numbering will be according to LCN (as defined by operator) or
not
Active Antenna: Before connecting your antenna to the receiver, please read the user manual of your
antenna regarding antenna powering. This parameter is recommended to set to
On only for active internal or external antennas which require power supply via an
antenna cable with voltage of 5 V DC and consume less than 50 mA. In all other cases
please leave this parameter as Off.

7.2 Channel

Press MENU and select the Channel chapter.
This chapter provides options to organize your channels according to your preferences.
It consists of the following sub-menus: Channel Manager and Favorite List
7.2.1 Channels Manager
This sub-menu allows to lock, delete, skip, rename or to move of stored in receiver channels.
NOTE:
Lock
You can block certain channels from being viewed by other people, i.e. children. To lock a channel:
- use p/q to select a channel;
- press RED. The selected channel will be marked as locked with a confirmation symbol in the lock
column;
- proceed as described for any other channels you wish to lock.
NOTE:
NOTE:
Delete
To delete a channel from the channel list of your receiver:
use p/q to select a channel;
„ „
press GREEN. The selected channel will be marked for deletion with a confirmation symbol in
„ „
the delete column.
A confirmation banner will be displayed. Select Yes to delete the marked channels or No to cancel
deletion.
16
To edit your channel preferences, it is required to enter the PIN-code to
access the edit functions (default PIN-code 0000).
Watching a blocked channel will be possible only after entering your PIN
code. Please check if the parameter System Lock in the Child Lock submenu
is set to "ON". See chapter 7.4.2.
To unlock a channel, please proceed the same way.
English