Strong SRT 8203 User Manual page 25

English
7.4.5 Factory Reset
This item will reset your receiver to the default factory settings.
WARNING!
Use pq to select this item and then press OK or u to restore the factory setting and to delete all earlier
found channels and earlier made settings.
You will be asked to enter your current PIN code (or, if it was not changed, enter default PIN code 0000).
7.4.6 Update
This feature allows you to update the receiver software via the USB port.
When a new software is available for your receiver, it can be downloaded from our website www.strong.tv.
WARNING!
For the USB upgrading procedure, please follow the provided instruction on the website.
WARNING!
After an update the receiver restarts automatically.
7.4.7 Information
This sub-menu shows receiver specific information such as hardware, software and firmware information
and build date.
7.4.8 Auto Standby
Auto Standby is a feature that helps you reducing power consumption.
When set to 1hr/2hr or 3hr, the receiver will switch to standby mode if it doesn't receive any commands
during this time (in hours).
Set Auto Standby to Off to deactivate the automatic standby function.
7.5 AV
Use this sub-menu to match your receiver to your TV set.
The following settings are available:
Aspect Ratio Use this option to select the aspect ratio of your TV and the preferred conversion
method. The options are: Full Screen - Displays broadcast on full screen on your TV, 4:3
PS - Displays 16:9 widescreen broadcasts full screen on your 4:3 TV, 4:3 LB - black bars
on top and under the picture on a 4:3 TV and 16:9 - use this setting for 16:9 TV sets
Video Resolution Use this option to select the video resolution of your TV screen. The options are: Auto
Detect (automatic detection of video resolution offered to the receiver) and manual
selections from 480i_30 up to 1080p_60. Please use a setting that matches and not
exceed the specifications for resolution of your TV. Selection above 576i is only
applicable on HDMI output
By resetting your receiver to the factory defaults, all your settings and stored
channels will be permanently deleted. Please use this option with care.
After restoring of Factory Defaults, the Init Install menu will appear on your
TV screen.
The software update procedure will permanently delete all your settings
and stored channels. Please use this option with care. After this procedure
the Init Install menu will appear on your TV screen.
During the upgrade process NEVER disconnect the receiver from the mains
or switch off the power! Doing so might damage your receiver and will void
warranty!
21