Perform The Firmware Update Using Micro Sd Memory Card (3Rw5 Hmi High Feature) - Siemens SIRIUS 3RW51 Equipment Manual

Maintenance and servicing

10.3 Perform the firmware update using micro SD memory card (3RW5 HMI High feature)

Procedure
1. Make sure that the motor is switched off and you do not start the motor during the firmware
update.
A control command for starting the motor is not supported during the firmware update.
To ensure the quickest and most fault-free firmware update, it is recommended that you
disconnect the main voltage (operating voltage) of the 3RW51 soft starter and set the CPU /
PLC to STOP operating state.
2. Perform the update of the device firmware.
– With a micro SD memory card via the 3RW5 HMI High Feature (Page 154)
Result
You have performed a firmware update for the selected device. The selected device
automatically restarts.
Note
Firmware update of the 3RW5 HMI High Feature:
Please note that the display switches off for about 30 seconds when the firmware is activated.
10.3 Perform the firmware update using micro SD memory card (3RW5
HMI High feature)
Requirements
• Micro SD memory card with valid firmware file (*.upd)
• The valid firmware file is located in the root directory (topmost level)
• 3RW5 HMI High Feature
Menu: "Micro SD card > FW update"
• Access protection to 3RW5 HMI High Feature is not active or has been reset.
Procedure
Note
Access to micro SD memory card.
Please note that the micro SD memory card is located in the 3RW5 HMI High Feature during
updating of the firmware.
Premature removal of the micro SD memory card from the 3RW5 HMI High Feature is not
permissible and will terminate updating of the firmware. Data could also be lost.
154
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
SIRIUS 3RW51 Soft Starter