Parameterize The Response To Bus Errors And Output - Siemens SIRIUS 3RW51 Equipment Manual

Procedure
1. Start programming mode pressing the MODE key longer than 2 s until the LED STATE /
OVERLOAD flickers green.
Press and hold the MODE key.
2. Also press the RESET / TEST key for longer than 2 s until the LED STATE / OVERLOAD illuminates
red.
The set state of ON / RUN relay output is displayed on SOFT TORQUE LED.
3. Release the MODE and RESET / TEST keys.
4. Switch the mode by pressing the MODE key briefly. The SOFT TORQUE LED switches between
flickering green and flashing green.
You can switch between the modes at the output as often as you want.
Note
If you do not press a key in programming mode for longer than 10 seconds , the 3RW51 soft
starter automatically terminates the programming mode.
5. Terminate programming mode by pressing the RESET / TEST key for longer than 1 second until
STATE / OVERLOAD LED no longer shines red.
Further parameterization options
• 3RW5 HMI High Feature (accessory)
Menu: "Parameters > Soft Starter > ON / RUN relay output"
6.8 Parameterize the response to bus errors and output 13, 14 (ON /
Requirements
• 3RW51 soft starter from firmware version V2.0.1
• During the activation you must be able to switch off the supply voltage (control supply
voltage).
SIRIUS 3RW51 Soft Starter
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
6.8 Parameterize the response to bus errors and output 13, 14 (ON /
SOFT TORQUE LED
Flashes green
Flickers green
Parameter assignment
Signal set at output 13 / 14
ON (factory setting)
RUN
79