Siemens SIRIUS 3RW51 Equipment Manual page 43

Procedure with door mounting kit IP65
• Remove the protective film from the adhesive tape on the seal and secure the seal on the rear
side of the 3RW5 HMI Standard
Ensure that the seal does not overlap.
• Place the 3RW5 HMI Standard in the cutout of the control cabinet door
• Continue to screw the screws into the fixing brackets
at the front. Fasten the fixing brackets onto the 3RW5 HMI Standard
• Tighten the 3RW5 HMI Standard with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
SIRIUS 3RW51 Soft Starter
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
4.5 Installing / mounting / removing 3RW5 HMI
①
.
③
Mounting and Dismantling
②
.
until they protrude approx. 10 mm
④
.
⑤
.
43