AudioCodes MediaPack Series Hardware Installation Manual page 3

High-density analog media gateway

Hide thumbs Also See for MediaPack Series:

Table of Contents

Notice

The Ethernet port interface cabling must be shielded and routed only indoors.

The device must be connected to a grounded power outlet.

Routing of FXS telephony cables: Routing FXS telephony cables outdoors can be done

only in conjunction with a three-electrode Gas Discharge Tube (GDT) rated at 350V

located at the entry point of the two-wire into the building, and properly grounded. When

done correctly, the installation will meet ITU-T K.21 requirements.

Caution Electrical Shock: Do not open or disassemble this device. The device

carries high voltage and contact with internal components may expose you to electrical

shock and bodily harm.

The device must be installed and serviced only by qualified service personnel.

The device must be installed only in restricted access locations that are compliant with

ETS 300 253 guidelines where equipotential bonding has been implemented.

Disconnect the device from the mains and Telephone Network Voltage (TNV) before

servicing.

For AC powered models, use only the AC power cord that is supplied with the device to

connect to the power source.

Mp-1288