AudioCodes MediaPack Series Hardware Installation Manual page 39

CHAPTER 5 Cabling the Device
5
6
7
8
➢ To connect the serial interface port to a computer:
1. Connect the RJ-45 connector, at one end of the cable, to the device's serial port (labeled
|0|0|), located on the CPU module on the rear panel.
2.
Connect the DB-9 connector, at the other end of the cable, to a COM RS-232
communication port on your PC.
The RS-232 port is not intended for permanent connection.
RJ-45
Internally used
Receive Data (RXD)
Ground (GND)
Internally used
Figure 5-18: Connecting Serial Interface
- 33 -
MP-1288 | Hardware Installation Manual
DB-9 Female
5
3 Transmit
4 Ground
(GND)
7
used
Not
used
Data
(TXD)
Not
used