AudioCodes MediaPack Series Hardware Installation Manual page 32

CHAPTER 5 Cabling the Device
2. Connect the Patch Panel's 50-pin male connector to one of the FXS blade's 50-pin female
Telco connectors located on the chassis' rear panel, and secure the connector with the
two captive screws located on either side of the connector, using a flat-head screwdriver:
Figure 5-9:
3. Connect your analog equipment to the Patch Panel, by plugging the RJ-11 connectors into
the RJ-11 sockets on the Patch Panel's front panel:
Figure 5-8: Mounting Patch Panel in Rack
Connecting 50-Pin Telco Connector to Port on FXS Blade
- 26 -
MP-1288 | Hardware Installation Manual