AudioCodes MediaPack Series Hardware Installation Manual page 41

CHAPTER 5 Cabling the Device
Figure 5-19: Swinging Cable Anchor Clip away from Power Inlet
2. Plug the female end of the AC power cord (supplied) into the power inlet.
3. Secure the power cord to the power inlet by providing strain relief, using the cable anchor
clip. Slide the cable anchor clip sideways, towards the power inlet and then push the
power cord into the cable anchor clip, as shown in the following figure. This protects the
plug from accidentally being pulled out.
Figure 5-21: Strain Relief for Power Cord using Cable Anchor Clip
Strain relief for the power cord using the cable anchor clip is not mandatory.
4.
Connect the male end of the power cord to a standard AC electrical outlet.
5. If you are using both Power Supply modules, repeat steps 1 through 3 for connecting the
second Power Supply module, but using the power socket associated with the second
Power Supply module and connecting this to a different supply circuit.
6. Turn on the power at the power source (if required).
7.
Check that the LED on each Power Supply module (front panel) is lit green, indicating that
the device is receiving power. For more information on the power LED, see
LED on page 16 .
Figure 5-20: Connecting to Power
- 35 -
MP-1288 | Hardware Installation Manual
Power Supply