AudioCodes MediaPack Series Hardware Installation Manual page 56

CHAPTER 6 Hardware Maintenance
3. Install the new CPU module:
a. Hold the front part of the module with one hand and place your other hand under the
module to support it.
b. Orientate the module as shown above and align the module with the guiding rails in
the chassis slot.
c. Gently slide the module into the slot until it has engaged with the chassis backplane.
d.
Secure the module to the chassis, by tightening the two Philips screws on the module.
You can use a Phillips or flathead screwdriver.
e. Attach the network cables to the module.
f. Power up the device.
Figure 6-18: Removing CPU Module on Rear Panel
MP-1288 | Hardware Installation Manual
- 50 -