Danfoss VLT AutomationDrive FC 301 Operating Manual page 4

VLT® AutomationDrive FC 301/FC 302
Operating Guide
4.8 Installation Check List
5 Commissioning
5.1 Safety Instructions
5.1.1 Before Applying Power
5.2 Local Control Panel Operation
5.3 System Set-up
6 Basic I/O Configuration
6.1 Application Examples
6.1.1 Programming a Closed-loop Drive System
6.1.2 Wiring Configuration for Automatic Motor Adaptation (AMA)
6.1.3 Wiring Configuration for Automatic Motor Adaptation without T27
6.1.4 Wiring Configuration: Speed
6.1.5 Wiring Configuration: Feedback
6.1.6 Wiring Configuration: Run/Stop
6.1.7 Wiring Configuration: Start/Stop
6.1.8 Wiring Configuration: External Alarm Reset
6.1.9 Wiring Configuration: RS485
6.1.10 Wiring Configuration: Motor Thermistor
6.1.11 Wiring for Regen
6.1.12 Wiring Configuration for a Relay Setup with Smart Logic Control
6.1.13 Wiring Configuration: Mechanical Brake Control
6.1.14 Wiring Configuration for the Encoder
6.1.15 Wiring Configuration for Torque and Stop Limit
7 Maintenance, Diagnostics, and Troubleshooting
7.1 Maintenance and Service
7.2 Warning and Alarm Types
7.3 Warning and Alarm Displays
7.4 Descriptions of Warnings and Alarms
8 Specifications
8.1 Electrical Data
8.1.1 Mains Supply 200-240 V
8.1.2 Mains Supply 380-500 V
8.1.3 Mains Supply 525-600 V (FC 302 only)
8.1.4 Mains Supply 525-690 V (FC 302 only)
8.1.5 Power Cable Cross-sections
8.2 Mains Supply
4 | Danfoss A/S © 2021.01
Contents
AQ267037727118en-000101/130R0300
20
22
22
22
23
24
25
25
25
26
26
27
29
31
33
35
36
36
37
38
39
39
41
43
43
43
44
44
60
60
60
62
65
67
70
70