Wiring Configuration For A Relay Setup With Smart Logic Control - Danfoss VLT AutomationDrive FC 301 Operating Manual

VLT® AutomationDrive FC 301/FC 302
Operating Guide

6.1.12 Wiring Configuration for a Relay Setup with Smart Logic Control

Table 26: Wiring Configuration for a Relay Setup with Smart Logic Control
Drive
12
+24 V
+24 V 13
18
D IN
19
D IN
20
COM
27
D IN
29
D IN
32
D IN
33
D IN
D IN 37
50
+10 V
A IN
53
A IN
54
COM
55
A OUT
42
COM 39
01
02
03
04
05
06
38 | Danfoss A/S © 2021.01
Parameters
To disable regen, decrease parameter 1-90 Motor Thermal Protection to 0%. If the application
uses motor brake power and regen is not enabled, the unit trips.
Parameters
Function
Parameter 4-30 Motor Feedback Loss Function
Parameter 4-31 Motor Feedback Speed Error
Parameter 4-32 Motor Feedback Loss Timeout
Parameter 7-00 Speed PID Feedback Source
Parameter 17-11 Resolution (PPR)
Parameter 13-00 SL Controller Mode
Parameter 13-01 Start Event
Parameter 13-02 Stop Event
Parameter 13-10 Comparator Operand
Parameter 13-11 Comparator Operator
Parameter 13-12 Comparator Value
Parameter 13-51 SL Controller Event
Parameter 13-52 SL Controller Action
Parameter 5-40 Function Relay
*=Default value
Notes/comments:
If the limit in the feedback monitor is exceeded, warning 90, Feedback Mon. is issued. The SLC
monitors warning 90, Feedback Mon. and if the warning becomes true, relay 1 is triggered. Ex-
ternal equipment may require service. If the feedback error goes below the limit again within
5 s, the drive continues and the warning disappears. Reset relay 1 by pressing [Reset] on the
LCP.
Basic I/O Configuration
Setting
[1] Warning
100 RPM
5 s
[2] MCB 102
1024*
[1] On
[19] Warning
[44] Reset key
[21] Warning no.
[1] ≈ (equal)*
90
[22] Comparator 0
[32] Set digital out A low
[80] SL digital output A
AQ267037727118en-000101 / 130R0300