Table of Contents
Advertisement
6.
Remove the two screws, and detach the PS cover.
Pin stopper
PSW3 x 6
Note
When installing the pin stopper, match the boss with the hole.
7.
Remove the two screws, and detach the RE-291 board from the connector (CN5007) on the PS-836 board.
RE-291 board
PS-836 board
8.
Remove the screw, and detach the heat sink retainer and thermal sheet.
9.
Remove the hexagon support.
10. Remove the four screws, and detach the PS-836 board.
HDC4300
PSW3 x 6
Hole
Boss
PSW3x 6
CN5007
PS cover
4-29
Advertisement
Table of Contents
