Table of Contents
Advertisement
4.
Remove the four screws, and detach the lug harness and optical multi cable assembly.
Earth lug
Lug harness
B3 x 8
Note
When installing the optical multi cable assembly, install it so that the red mark is located shown in the figure.
5.
Install the removed parts by reversing the steps of removal.
4-3-6.
PROMPTER Connector
Preparation
1.
Remove the outside panel assembly. (Refer
Procedure
1.
Remove the two screws, and detach the BNC cap, and bracket BNC.
2.
Disconnect the coaxial cable from the PROMPTER connector.
HDC4300
Earth lug
B2 x 5
Connector housing
Optical multi cable assembly
Red mark
B3 x 8
to"4-3-1. Outside Panel
Assembly")
Clamper
Optical fiber
cables
Tape AS
4-13
Advertisement
Table of Contents
