Table of Contents
Advertisement
6-2.
PLD
This unit uses the PLD (Programmable Logic Device) that supports USB drive to write and rewrite the internal data.
If the part listed below needs to be replaced or to be upgraded, contact your local Sony Sales Office/Service Center.
Note
The part number of PLD (or ROM for PLD) in which data is not written yet, is shown in
Therefore, if part replacement is required, write the data by the following procedure.
In the case of the PLD type that runs on the program stored in external ROM, data needs not to be written only by
replacing the part if the specific PLD only is defective.
6-2-1.
Corresponding PLD
PLD (Ref. No./Board Name)
IC1001/SY-408
*1
IC1102/SY-408
IC700/DPR-370
IC701/DPR-370
*2
(Config-ROM)
IC1300/DPR-370
IC1309/DPR-370
*3
(Config-ROM)
IC201/MEM-147
*4
IC402/MEM-147
(Config-ROM)
IC901/MEM-147
*5
IC1203, IC1204/MEM-147
(Config-ROM)
IC001/TX-146
IC004/TX-146
*6
(Config-ROM)
6-2-2.
Upgrading PLD Data
Equipment Required
USB drive (commercially available)
Tip
For recommended USB drive, refer to "Using a USB Drive" in the operation manual.
Preparation
Copy PLD update data to the USB drive using the following procedure.
Note
For how to obtain the version update data file (hdc4300_sy.pkg, hdc4300_dpr1.pkg, hdc4300_dpr2.pkg, hdc4300_
mem1.pkg, hdc4300_mem2.pkg, hdc4300_tx.pkg), contact your local Sony Sales Office/Service Center.
1.
Create the following directory in the USB drive.
\MSSONY\PRO\CAMERA\HDC4300
2.
Copy the PLD version update data file to be updated to the directory created.
*1:
IC1102 (SY-408) is the ROM for IC1001 (SY-408).
*2:
IC701 (DPR-370) is the ROM for IC700 (DPR-370).
*3:
IC1309 (DPR-370) is the ROM for IC1300 (DPR-370).
*4:
IC402 (MEM-147) is the ROM for IC201 (MEM-147).
*5:
IC1203, IC1204 (MEM-147) is the ROM for IC901 (MEM-147).
*6:
IC004 (TX-146) is the ROM for IC001 (TX-146).
HDC4300
"10. Spare
File Name
hdc4300_sy.pkg
hdc4300_dpr2.pkg
hdc4300_dpr1.pkg
hdc4300_mem2.pkg
hdc4300_mem1.pkg
hdc4300_tx.pkg
Parts".
6-3
Advertisement
Table of Contents
