Optical Multi Cable Assembly - Sony HDC4300 Service Manual

3. Remove the two screws, and detach the CN bracket (CN-3434).
4. Remove the two screws, and detach the CN-3434 board.
Fine-wire coaxial cable
CN001
PSW2 x 5
Hole
CN-3434 board
Fine-wire coaxial cable
CN-3434 board
Notes
• When installing the CN-3434 board, match the two bosses with the two holes.
• When installing the fine-wire coaxial cable, attach the UL tape at the location shown in the figure.
5. Install the removed parts by reversing the steps of removal.
4-3-5.

Optical Multi Cable Assembly

Preparation
1. Remove the outside panel assembly. (Refer
2. Remove the MEM-147 board assembly. (Refer
Procedure
1. Remove the screw, and detach the earth lug.
2. Remove the tape AS.
3. Release the two optical fiber cables from the clamper.
HDC4300
UL tape
Hole
Bosses
UL tape
to"4-3-1. Outside Panel
to"4-3-2. MEM-147 Board/TX-146
PSW2 x 5
CN bracket (CN-3434)
Assembly")
Board")
4-12