Ohb Block; Ohb Assembly - Sony HDC4300 Service Manual

Hide thumbs Also See for HDC4300:
Table of Contents

Advertisement

4-6.

OHB Block

4-6-1.

OHB Assembly

Preparation
1.
Remove the inside panel assembly. (Refer
2.
Remove the outside panel assembly. (Refer
3.
Remove the front assembly. (Refer
Procedure
1.
Disconnect the harness from the connector (CN3) on the IF-1278 board.
2.
Loosen the two screws, and remove the FD assembly from the OHB assembly.
IF-1278 board
3.
Remove the four screws and four washers, and detach the front panel assembly.
Front panel assembly
SW3
M3 x 8
(Tightening torque: 1.1 N•m)
4.
Install the removed parts by reversing the steps of removal.
HDC4300
to"4-2. Inside Panel
to"4-3-1. Outside Panel
to"4-5. Front
Assembly")
OHB assembly
FD assembly
CN3
Harness
Attached screws
(Tightening torque: 0.53 N•m)
Assembly")
Assembly")
OHB assembly
4-19

Advertisement

Table of Contents
loading

Table of Contents