Table of Contents
Advertisement
5-6-2.
Manual RPN Compensation Adjustment
When RPN is not compensated after RPN automatic compensation was performed, execute the manual RPN
compensation adjustment.
Preparation
1.
Execute RPN automatic compensation(APR).
Procedure
1.
Open following page by camera setup menu.
MENU : SERVICE
PAGE : MANUAL RPN
<MANUAL RPN>
RPN CH SELECT
RPN CURSOR
CURSOR H POS.
CURSOR V POS.
CURSOR JUMP
RPN WIDTH
RECORD RPN
DELETE RPN
MONITOR SEL
2.
Select the channel (R, G, or B) that is to be compensated.
ITEM: RPN CH SELECT → R, G, B
3.
Display the cross cursor.
ITEM: RPN CURSOR → ON
4.
Set the cross cursor center at the target RPN.
ITEM: CURSOR H POS.
ITEM: CURSOR V POS.
5.
Execute record of RPN compensation adjustment data.
ITEM: RECORD RPN → EXEC
A message "RECORD DATA OK? YES → NO" is displayed.
Note
In the case of RPN is disappeared in the screen, perform step 6.
In the case of RPN is appeared in the screen, the cross cursor may not move to the position of RPN. Perform
procedures as follows.
(1) Select(turn the knob) "NO" by rotary encoder and confirm(press the button).
(2) Shift the center of cross cursor by one line or one pixel and move to position of RPN.
(3) Perform step 5.
6.
Select(turn the knob) "YES" by rotary encoder and confirm(press the button).。
The message "COMPLETE" is displayed, the compensation data is recorded.
Tip
If a compensation pixel has been wrongly recorded, delete the RPN data.
ITEM: DELETE RPN → EXEC
7.
Repeat steps 4 to 6 to compensate other RPNs.
HDC4300
S03 TOP
:
R
:
OFF
:
1008
:
576
:
CURR
:
1
:
EXEC
:
EXEC
: YPbPr
5-31
Advertisement
Table of Contents
