Figure 78 Mvr Group Configuration; Table 55 Mvr Group Configuration - ZyXEL Communications GS-3012 Series User Manual

Chapter 21 Multicast
A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.

Figure 78 MVR Group Configuration

The following table describes the labels in this screen.

Table 55 MVR Group Configuration

LABEL
Multicast VLAN
ID
Name
Start Address
End Address
Add
Cancel
MVLAN
Name
Start Address
End Address
158
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-
down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal
notation.
Refer to Section 21.1.1 on page 149
Enter the ending IP multicast address of the multicast group in dotted decimal
notation.
Enter the same IP address as the Start Address field if you want to configure only
one IP address for a multicast group.
Refer to Section 21.1.1 on page 149
Click Add to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to discard all changes.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
for more information on IP multicast addresses.
for more information on IP multicast addresses.
GS-3012/GS-3012F User's Guide