Firmware Upgrade; Figure 88 Restore Configuration; Figure 89 Backup Configuration - ZyXEL Communications GS-3012 Series User Manual

Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Clicking the Apply or Add button does NOT save the changes permanently.
All unsaved changes are erased after you reboot the switch.
24.4 Reboot System
Reboot System allows you to restart the switch without physically turning the power off. It
also allows you to load configuration one (Config 1) or configuration two (Config 2) when
you reboot. Follow the steps below to reboot the switch.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to reboot
and load configuration one. The following screen displays.
Figure 89 Reboot System: Confirmation
2 Click OK and then wait for the switch to finish rebooting before you attempt to access
the switch again. This takes up to two minutes. This does not affect the switch's
configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the switch.

24.5 Firmware Upgrade

Click Firmware Upgrade in the Maintenance screen if you want to upgrade your switch
firmware. See the System Info screen to verify your current firmware version number. Make
sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong model
firmware may damage your device.
From the Maintenance screen, display the Firmware Upgrade screen as shown next.
GS-3012/GS-3012F User's Guide
Chapter 24 Maintenance
169