Enabling Rstp; Configuration File Maintenance; Backing Up Configuration; Figure 134 Traceroute Command Example - ZyXEL Communications GS-3012 Series User Manual

Chapter 33 Command Examples
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of 192.168.1.100.

Figure 134 traceroute Command Example

sysname> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:

33.5 Enabling RSTP

To enable RSTP on a port, enter
need to use "
RSTP on port 3.

Figure 135 Enable RSTP Command Example

sysname(config)# spanning-tree 3
sysname(config)# spanning-tree

33.6 Configuration File Maintenance

This section shows you how to backup or restore the configuration file on the switch using
TFTP.

33.6.1 Backing up Configuration

Syntax:
copy running-config tftp <ip> <remote-file>
where
244
= Specifies the network interface or the VLAN ID to
[in-band|out-of-
band|vlan <vlan-
id> ]
= Specifies the Time To Live (TTL) period.
[ttl <1-255>]
= Specifies the time period to wait.
[wait <1-60>]
= Specifies how many tries the switch performs the
[queries <1-10>]
spanning-tree
" to enable RSTP on the switch. The following example enables
spanning-tree
= The IP address of a TFTP server on which you want to
<ip>
store the backup configuration file.
= Specifies the name of the configuration file.
<remote-file>
which the Ethernet device belongs.
traceroute function.
followed by the port number. You also
GS-3012/GS-3012F User's Guide