Figure 85 Static Routing: Summary Table; Table 58 Static Routing: Summary Table - ZyXEL Communications GS-3012 Series User Manual

Chapter 23 Routing Protocol
Table 57 Static Routing (continued)
LABEL
Gateway IP
Address
Metric
Add
Cancel
Clear
View the current static routes on the switch in the summary table at the bottom of the screen.

Figure 85 Static Routing: Summary Table

The following table describes the labels in the summary table.

Table 58 Static Routing: Summary Table

LABEL
Index
Active
Name
Destination
Address
Subnet Mask
Gateway
Address
Metric
Delete
Cancel
166
DESCRIPTION
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
switch that will forward the packet to the destination. The gateway must be a router on
the same segment as your switch.
The metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Click Add to insert a new static route in the summary table below and save your
changes to the switch's run-time memory. The switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Click Clear to clear the fields to the factory defaults.
DESCRIPTION
This field displays the index number of the route. Click a number to edit the static
route entry.
This field displays Yes when the static route is activated and NO when is it
deactivated.
This field displays the descriptive name for this route. This is for identification
purpose only.
This field displays the IP network address of the final destination.
This field displays the subnet mask for this destination.
This field displays the IP address of the gateway. The gateway is an immediate
neighbor of your switch that will forward the packet to the destination.
This field displays the cost of transmission for routing purposes.
Check the rule(s) that you want to remove in the Delete column, and then click the
Delete button.
Click Cancel to clear the selected checkboxes in the Delete column.
GS-3012/GS-3012F User's Guide