Garp Status; Garp Timer; Figure 160 Garp Status Command Example - ZyXEL Communications GS-3012 Series User Manual

34.4.1 GARP Status

Syntax:
show garp
This command shows the switch's GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.

Figure 160 garp status Command Example

sysname# show garp

GARP Timer

------------------------
Join Timer
Leave Timer
Leave All Timer
sysname#
34.4.2 GARP Timer
Syntax:
garp join <msec> leave <msec> leaveall <msec>
where
This command sets the switch's GARP timer settings, including the join, leave and leave all
timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All
message terminates all registrations. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800
milliseconds and the Leave All Timer to 11000 milliseconds.
sysname(config)# garp join 300 leave 800 leaveall 11000
GS-3012/GS-3012F User's Guide
:200
:600
:10000
This sets the duration of the Join Period timer for GVRP
join <msec>
=
in milliseconds. Each port has a Join Period timer. The
allowed Join Time range is between 100 and 32767
milliseconds; the default is 200 milliseconds.
This sets the duration of the Leave Period timer for
leave <msec>
=
GVRP in milliseconds. Each port has a single Leave
Period timer. Leave Time must be two times larger than
Join Timer; the default is 600 milliseconds.
leaveall <msec>
This sets the duration of the Leave All Period timer for
=
GVRP in milliseconds. Each port has a single Leave
All Period timer. Leave All Timer must be larger than
Leave Timer; the default is 10000 milliseconds.
Chapter 34 IEEE 802.1Q Tagged VLAN Commands
259