Table of Contents
Advertisement
Table 117 AppPatrol > Other > Edit (continued)
LABEL
Priority
Maximize
Bandwidth
Usage
Log
OK
Cancel
27.11 Application Patrol Statistics
This screen displays a bandwidth usage graph and statistics for selected protocols.
Click AppPatrol > Statistics to open the following screen.
27.11.1 Application Patrol Statistics: General Setup
Use the top of the AppPatrol > Statistics screen to configure what to display.
Figure 310 AppPatrol > Statistics: General Setup
ZyWALL USG 1000 User's Guide
DESCRIPTION
Enter a number between 1 and 7 to set the priority for traffic that matches this
policy. The smaller the number, the higher the priority.
Traffic with a higher priority is given bandwidth before traffic with a lower priority.
The ZyWALL uses a fairness-based (round-robin) scheduler to divide bandwidth
between traffic flows with the same priority.
The number in this field is ignored if the incoming and outgoing limits are both set to
0. In this case the traffic is automatically treated as being set to the lowest priority
(7) regardless of this field's configuration.
Enable maximize bandwidth usage to let the traffic matching this policy "borrow"
any unused bandwidth on the out-going interface.
After each application or type of traffic gets its configured bandwidth rate, the
ZyWALL uses the fairness- based scheduler to divide any unused bandwidth on
the out-going interface amongst applications and traffic types that need more
bandwidth and have maximize bandwidth usage enabled.
This field controls what kind of record the ZyWALL creates when traffic matches
this policy. Please see
Chapter 46 on page 625
no - the ZyWALL does not record anything
log - the ZyWALL creates a record in the log
log alert - the ZyWALL creates an alert
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
Chapter 27 Application Patrol
for more information.
399
Advertisement
Table of Contents
Troubleshooting
