ZyXEL Communications Unified Security Gateway ZyWALL 1000 User Manual page 677

Table 242 IKE Logs (continued)
LOG MESSAGE
Cannot resolve My IP
Addr %s for Tunnel
[%s]
Cannot resolve Secure
Gateway Addr %s for
Tunnel [%s]
Could not dial dynamic
tunnel "%s"
Could not dial
incomplete tunnel "%s"
Could not dial manual
key tunnel "%s"
DPD response with
invalid ID
DPD response with no
active request
IKE Packet Retransmit
Phase 1 IKE SA process
done
Recv Main Mode request
from [%s]
Recv Aggressive Mode
request from [%s]
Recv DPD request from
"%s:%s"
Recv DPD response from
"%s:%s"
Recv:[SA]%s[KE]%s[ID]
%s[CERT]%s[CR]%s[HASH
]%s[SIG]%s[NONCE]%s[D
EL]%s[VID]%s[ATTR]%s
Send Main Mode request
to [%s]
Send Aggressive Mode
request to [%s]
Send DPD request to
"%s:%s"
Send DPD response to
"%s:%s"
Send:[ID]%s[SA]%s[KE]
%s[ID]%s[CERT]%s[CR]%
s[HASH]%s[SIG]%s[NONC
E]%s[DEL]%s[VID]%s[AT
TR]%s[
Start Phase 2: Quick
Mode
ZyWALL USG 1000 User's Guide
DESCRIPTION
1st %s is my ip address. 2nd %s is the tunnel name. When selecting a
matched proposal in phase-1, the engine could not get My-IP address.
1st %s is my ip address. 2nd %s is the tunnel name; When selecting a
matched proposal in phase-1, the engine could not get the correct
secure gateway address.
%s is the tunnel name. The tunnel is a dynamic tunnel and the device
cannot dial it.
%s is the tunnel name. The tunnel setting is not complete.
%s is the tunnel name. The manual key tunnel cannot be dialed.
When receiving a DPD response with invalid ID ignored.
When receiving a DPD response with no active query.
When retransmitting the IKE packets.
When Phase 1 negotiation is complete.
%s is the remote name; When receiving a request to enter Main mode.
%s is the remote name; When receiving a request to enter Aggressive
mode.
%s:%s is peer IP:Port. The device received a Dead Peer Detection
request.
%s:%s is peer IP:Port. The device received a Dead Peer Detection
response.
This is a combined message for incoming IKE packets.
%s is the remote name. The device sent a request to enter Main Mode.
%s is the remote name. The device sent a request to enter Aggressive
Mode.
%s:%s is peer IP:Port. The device sent a Dead Peer Detection request
to the peer.
%s:%s is peer IP:Port. The device sent a DPD response sent to the
peer.
This is a combined message for outgoing IKE packets.
Indicates the beginning of phase 2 using quick mode.
Appendix B Log Descriptions
677