Figure 142 Network > Interface > Add; Table 62 Network > Interface > Add - ZyXEL Communications Unified Security Gateway ZyWALL 1000 User Manual

Chapter 10 Interface
Figure 142 Network > Interface > Add
Each field is described in the table below.
Table 62 Network > Interface > Add
LABEL
Virtual Interface Properties
Interface Name
Description
IP Address Assignment
IP Address
Subnet Mask
Gateway
Metric
Interface Properties
Upstream
Bandwidth
Downstream
Bandwidth
218
DESCRIPTION
This field is read-only. It displays the name of the virtual interface, which is
automatically derived from the underlying Ethernet interface, VLAN interface, or
bridge interface.
Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and ()+/:=?!*#@$_%-
characters long.
Enter the IP address for this interface.
Enter the subnet mask of this interface in dot decimal notation. The subnet
mask indicates what part of the IP address is the same for all computers in the
network.
Enter the IP address of the gateway. The ZyWALL sends packets to the
gateway when it does not know how to route the packet to its destination. The
gateway should be on the same network as the interface.
Enter the priority of the gateway (if any) on this interface. The ZyWALL decides
which gateway to use based on this priority. The lower the number, the higher
the priority. If two or more gateways have the same priority, the ZyWALL uses
the one that was configured first.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
send through the interface to the network. Allowed values are 0 - 1048576.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
receive from the network through the interface. Allowed values are 0 - 1048576.
characters, and it can be up to 60
ZyWALL USG 1000 User's Guide