Bridge Add/Edit - ZyXEL Communications Unified Security Gateway ZyWALL 1000 User Manual

Chapter 10 Interface
Table 57 Network > Interface > Bridge (continued)
LABEL
IP Address
Member
Add icon
Apply
Reset

10.5.4 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP
settings, and ping check for each bridge interface. To access this screen, click the Add icon at
the top of the Add column in the Bridge Summary screen, or click an Edit icon in the Bridge
Summary screen. The following screen appears.
206
DESCRIPTION
This field displays the current IP address of the interface. If the IP address is
0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC)
or dynamically assigned (DHCP). IP addresses are always static in virtual
interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the bridge
interface. It is blank for virtual interfaces.
This column lets you create, edit, remove, activate, and deactivate interfaces.
To create a bridge interface, click the Add icon at the top of the column. The
Bridge Add/Edit screen appears.
To create a virtual interface, click the Add icon next to the corresponding bridge
interface. The Virtual Interface Add/Edit screen appears. See
page 217.
To edit an interface, click the Edit icon next to it. The Bridge Add/Edit screen
or Virtual Interface Add/Edit screen appears accordingly.
To remove an interface, click the Remove icon next to it. The ZyWALL confirms
you want to remove it before doing so.
To activate or deactivate an interface, click the Active icon next to it. Make sure
you click Apply to save and apply the change.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Section 10.8 on
ZyWALL USG 1000 User's Guide