Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 163 User/Group > Setting > Force User Authentication Policy > Add/Edit
LABEL
Enable
Description
Authentication
Source Address
Destination
Address
Schedule
OK
Cancel
34.5 Web Configurator for Non-Admin Users
Access users cannot use the Web configurator to browse the configuration of the ZyWALL.
Instead, when access users log in to the ZyWALL (forced in the screen as shown in
on page 510
Figure 377 Web Configurator for Non-Admin Users
ZyWALL USG 1000 User's Guide
DESCRIPTION
Select this if you want this condition to be active.
Enter a description for this condition. It can be up to 60 printable ASCII characters
long.
Select whether users must log in (force) or whether users do not have to log in
(skip) when this condition is checked and satisfied.
Select a source IP address object or select Create Object to configure a new one.
Select any if this condition applies to traffic from all source addresses.
Select the destination address of traffic to which this condition applies or select
Create Object to configure a new one. Select any if this condition applies to traffic
from all destination addresses.
Select the schedule object that specifies when this condition applies or select
Create Object to configure a new one (see
Select none if this condition always applies.
Select this to save your changes and return to the previous screen.
Select this to return to the previous screen without saving any changes.
or otherwise), the following screen appears.
Chapter 34 User/Group
Chapter 37 on page 527
for details).
Figure 375
513
Advertisement
Table of Contents
Troubleshooting
