Figure 111 Advanced: Static Route; Table 52 Advanced: Static Route - ZyXEL Communications Vantage Service Gateway VSG-1200 V2 User Manual

VSG-1200 V2 User's Guide

Figure 111 Advanced: Static Route

The following table describes the labels in this screen.

Table 52 Advanced: Static Route

LABEL
Static Route
No.
Destination IP
Address
Destination
Subnet Mask
Gateway IP
Address
Hop Count
Interface
Apply
Static Route Table This table displays the static routes configured.
No.
Destination IP
Address
Destination
Subnet Mask
165
DESCRIPTION
Set the fields below to configure static route settings. You can configure up to 20
static routes at a time.
This is the index number of the static route that you chose in menu 12.1.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Type the subnet mask for this destination.
Type the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Hop count represents the cost of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Select a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Specify whether the static route setting applies to the LAN or the WAN interface.
Click Apply to save the changes. New static route entries display in the table
below.
This field displays the index number.
This field displays the IP address of the final destination.
This field displays the subnet mask of the final destination.
Chapter 22 Static Route