Figure 39 System Setting: Billing: PMS Configuration
The following table describes the labels in this screen.
Table 21 System Setting: Billing: PMS Configuration
LABEL
Charge Mode (only
for Port-Location
Mapping enabled)
Regenerate
password of static
account with PMS
checkout.
PMS Type
Micros Fidelio
Revenue Code
Description
Chapter 10 Billing
DESCRIPTION
When you set up Port-Location Mapping, your VSG offers two billing modes:
Based on Room and Based on Subscriber.
Select Based on Room when location is important. If a subscriber disconnects
from one location and reconnects in another location, the VSG prompts for the
user name and password again.
Select Based on Subscriber to allow a subscriber to freely move between
different locations without prompting for user name and password.
Note: You must activate the port-location mapping feature. Refer
to
Chapter 13 on page
This feature is applicable when you select Scenario B with Built-in
Authentication in the Authentication screen (see
Select Enable to automatically generate a new password for the static account
when a subscriber checks out.
Select Disable to keep the password for the static account unchanged after a
subscriber checks out.
Select a PMS system and specify the fields below (if available). Currently the
VSG supports Micros Fidelio, Spectrum MK II, Marriott and Proprietary.
Enter a revenue code (between 01 and 99).
Enter the description for the revenue. Refer to the user's guide that comes with
your PMS device.
VSG-1200 V2 User's Guide
112.
Figure 32 on page
83).
92