Wan Type: Pppoe; Figure 167 Smt: Wan Configuration: Pppoe; Table 74 Smt: Wan Configuration: Static Or Dynamic Ip Address - ZyXEL Communications Vantage Service Gateway VSG-1200 V2 User Manual

VSG-1200 V2 User's Guide
The follow table describes the fields in this menu.

Table 74 SMT: WAN Configuration: Static or Dynamic IP Address

FIELD
WAN Type? (D/S/
P/T)
IP Address
Subnet Mask
Default Gateway
Primary/
Secondary DNS IP
Address
At the "S)ave and return R)eturn without saving M)odify:" prompt, type S and press [ENTER] to save the
changes and return to the previous screen, type R and press [ENTER] to discard all changes and return
to the previous screen or type M and press [ENTER] to continue configuring the fields. Restart the
device when prompted
Press [ESC] and enter Y to stop any actions in the current screen and return to the previous screen. All
changes will be discarded.

32.6.2 WAN Type: PPPoE

To activate PPPoE support on the VSG, enter P in the WAN Type field to display the WAN
Configuration screen as shown next. Refer to the related web configurator section for
background information.

Figure 167 SMT: WAN Configuration: PPPoE

WAN Type? (D/S/P/T)
Username
Password
Connect Setting? (C/K)
Max idle Time(Min)
Optional Setting
Service name
PPP MTU Setting
TCP MSS setting
219
DESCRIPTION
Enter D (Dynamic) to set the VSG to dynamically obtain an IP address and other
network information (IP address, DNS information etc.) from a DHCP server on the
WAN network. This is the default setting.
Enter S (Static) to set the VSG to use a static (or fixed) IP address. Then set the
following fields.
This field is available when you select S in the WAN Mode field.
Enter the static IP address assigned to you by your ISP or network administrator.
This field is available when you select D in the WAN Mode field.
Enter the subnet mask depending on your network needs. The default is
255.255.255.0. Refer to Appendix H on page 268
subnetting.
Enter the IP address of the default gateway.
Enter the IP address of the DNS server(s) in the Primary DNS IP Address and/or
Secondary DNS IP Address fields.
The default primary DNS server IP address is 168.95.1.1.
You must specify a DNS server if you set the VSG to use a static WAN IP address.
WAN Configuration
:P
:
:
:C
:10
:
:1492
:1452
if you are implementing
Chapter 32 Using The SMT